1. Double-ended input single-ended output circuit Communication analysis: As shown in the lower right figure is the equivalent circuit of the differential mode signal. When the differential mode signal acts, since the currents in the T1 and T2 tubes are equal in the opposite direction, the emitter is equivalent to ground. The output voltage half. If the polarity of the input differential mode signal does not change, and the output signal is taken from the collector of the T2 tube, the output is in phase with the input. When a common-mode signal is input, the polarities are the same because the input signals on both sides are equal in size. The equivalent circuit of the circuit on the side of the T1 tube related to the output voltage to the common mode signal is as follows It can be seen that the difference between the single-ended input circuit and the double-ended input circuit is that the differential mode signal input is accompanied by the common mode signal input. The output voltage Automotive Switch
Automotive Switches
Automotive Switches,ie, Car Switches are gradually enjoy a lager popularity in the Automobile industry , including Automotive Push Button Switches, Automotive Toggle Switches, Automotive Rocker Switches, Automotive Rotary Switches, Automotive Battery Switches.
Our Car Electrical Switches could equip with LED light or without light, which is according to our customer`s requirement. Meanwhile, our Automotive Push Button Switches could reach IP 67 waterproof rating. We have different shape of Automotive Electrical Switches for you to choose, comprising Square and Round.
Our Automotive Switches is normally used to turn on the car, and it is normally use the High Current to conduct the engine.
Automotive Switches,Custom Automotive Switches,Automotive Electrical Switches,Automotive Accessory Switches YESWITCH ELECTRONICS CO., LTD. , https://www.yeswitches.com
The circuit is shown on the right, as a double-ended input, single-ended output differential amplifier circuit. Due to the asymmetry of the circuit parameters, the static operating point and dynamic parameters are affected.
DC analysis:
Draw the DC path as shown in the lower right figure. In the figure, and are the equivalent power supply and resistance obtained by the Thevenin's theorem, and their expressions are: 
When the differential mode signal acts, the load resistance only obtains the amount of change in the collector potential of the T1 tube, so compared with the double-ended output circuit, the value of the differential mode amplification factor decreases. 
The analysis of the static operating point and dynamic parameters is completely the same as the double-ended input and double-ended output.
3. Single-ended input, single-ended output circuit
As shown on the right, there is a single-ended input and single-ended output circuit. The analysis of the static operating point, differential mode gain, common mode gain, input and output resistance of this circuit is the same as the single-ended output circuit. The analysis of the input signal is the same as the single-ended input circuit. 
